The Simpson Strong-Tie H3 18-Gauge Galvanized Hurricane Tie is a single-sided hurricane tie engineered to resist moderate loads at the rafter/truss-to-top-plate connection. As part of a continuous load path, the H3 resists both lateral and uplift loads, helping protect structures against wind and seismic forces. Available in left- and right-hand models, the H3 can be installed in pairs for versatile, code-recognized performance.

Key Features

• Provides a connection between the rafter or truss and the wall of the structure that helps resist wind and seismic forces
• Approved for installation with load-rated Strong-Drive SD Connector screws
• Use also for a variety of connections where one member crosses another
• Made from 18-gauge steel
• Galvanized (G90) for corrosion resistance

Specifications

• Model No.: H3
• Gauge: 18
• Width: 1 9/16 in.
• Height: 4 5/8 in.
• Coating/Finish: Zinc Galvanized, G90
• Country of Origin: United States

Approved Applications

• Rafter or truss to top-plate connection as part of a continuous load path
• Lateral and uplift load resistance in wind and seismic zones
• Variety of connections where one structural member crosses another
• Left-hand and right-hand installations; can be installed in pairs

Frequently Asked Questions

What fasteners are required to install the H3 Hurricane Tie?

Each tie requires (8) 0.131 in. x 2-1/2 in. nails or (8) #9 x 1-1/2 in. Strong-Drive SD Connector screws for a code-compliant installation.

Is the H3 available in both left-hand and right-hand orientations?

Yes. H3 ties are available in left- and right-hand models and can be installed in pairs to provide a balanced connection at the rafter or truss-to-top-plate joint.

Does the H3 Hurricane Tie replace solid blocking?

No. Hurricane ties do not replace solid blocking. Proper blocking should still be installed in accordance with applicable building codes and requirements.

What precaution should be taken when installing the H3 on plated trusses?

When installing ties on plated trusses on the side opposite the truss plate, do not fasten through the truss plate from behind. Doing so can force the truss plate off of the truss and compromise truss performance.

Related Products

• Nails 0.131 x 2-1/2"
• #9 x 1 1/2"

Note: Use hot-dip galvanized (HDG) nails with ZMAX and HDG connector products. Use Type 316 stainless-steel nails with stainless-steel connector products. Hurricane ties do not replace solid blocking. When installing ties on plated trusses (on the side opposite the truss plate) do not fasten through the truss plate from behind, as this can force the truss plate off of the truss and compromise truss performance.