The Simpson Ridge Rafter Connector for 2x6 by Simpson delivers a proven mechanical connection between a rafter and the ridge of a roof, engineered to outperform toenailing and screw fastening in both strength and consistency. Built from 18-gauge steel with a G90 zinc galvanized finish, this ridge rafter connector is a dependable choice for roof framing projects where accurate rafter alignment and long-term joint integrity are non-negotiable.

Key Features

• Easier and stronger than toenailing or screw fastening - reduces installation effort while producing a more reliable rafter-to-ridge connection that holds up over time.
• Interlocking top flange design - when connectors are used in pairs, the flanges interlock to keep opposing rafters in correct alignment, eliminating the guesswork of manual positioning.
• Accepts rafter slopes up to 30 deg. - accommodates a wide range of common roof pitches, making this connector versatile across residential and light commercial framing applications.
• Compatible with 2x6 rafters and larger - supports a minimum 2x6 member size, fitting standard dimensional lumber used in typical roof framing.
• Adaptable for rafter-to-face applications - flattening the top flange into the face plane converts the connector for face-mounting scenarios, adding flexibility on the job site without requiring a separate product.
• 18-gauge steel construction - provides the structural rigidity needed for load-bearing roof connections while keeping the connector lightweight and easy to handle during installation.
• G90 zinc galvanized finish - delivers an extra layer of corrosion resistance, helping the connector maintain its integrity in conditions where moisture exposure is a concern.

Why This Product

• A stronger alternative to traditional fastening methods - unlike toenailing or direct screw fastening, this ridge rafter connector creates a mechanical connection that distributes load more effectively at the rafter-to-ridge joint, supporting a more structurally sound roof assembly.
• Built-in alignment for paired installations - the interlocking top flange means contractors do not have to manually align opposing rafters, saving time during roof framing and reducing the risk of misalignment errors.
• Versatile enough for multiple connection types - with support for slopes up to 30 deg. and the ability to convert to a rafter-to-face connector by flattening the top flange, a single connector handles varied job site conditions without requiring additional hardware.
• Corrosion-resistant finish for lasting performance - the G90 galvanized coating goes beyond basic protection, making this connector a practical choice for roof framing applications where long-term durability matters.

Specifications

• Model No.: RR
• Gauge: 18
• Coating: Zinc Galvanized, G90
• Finish: Zinc Galvanized, G90
• Member Size: 2x6 (minimum)
• Install With: Install with 10d x 1-1/2 in. nails or #9 x 1-1/2 in. Strong-Drive SD screws
• Country of Origin: United States

Frequently Asked Questions

What is the minimum rafter size compatible with the Simpson RR Ridge Rafter Connector?

The minimum rafter size for use with the RR ridge rafter connector is 2x6.

What is the maximum rafter slope this connector can accommodate?

The RR ridge rafter connector can be used with rafter slopes up to 30 deg..

What fasteners should be used to install the Simpson RR connector?

Install with 10d x 1-1/2 in. nails or #9 x 1-1/2 in. Strong-Drive SD screws.

Can the Simpson RR connector be used as a rafter-to-face connector?

Yes. For a rafter-to-face connector application, flatten the top flange into the face plane.