The Simpson Heavy L-Shaped Angle HL43HDG is a heavy-gauge, hot-dip galvanized connector engineered to reinforce right-angle connections where two structural wood members meet at 90 deg. Built for demanding framing and construction applications, this L-shaped angle bracket delivers reliable corner stability and resistance to both uplift and lateral forces, making it a dependable choice for heavy-duty structural work.

Key Features

• L-shaped 90 deg. profile for right-angle connections - fits cleanly at the junction of two structural members, providing solid corner reinforcement without complex fitting or modification
• Heavy-gauge construction - delivers the load-bearing strength needed for demanding structural and framing applications where lighter connectors fall short
• Hot-dip galvanized coating - offers enhanced corrosion resistance compared to standard galvanized finishes, helping the connector hold up in moisture-prone and exposed environments
• Achieves lateral loads in both directions when installed in pairs - gives builders the flexibility to engineer connections that resist forces from multiple directions for greater structural integrity
• Compatible with bolt or lag screw installation - accepts lag screws of equal diameter as a substitute for bolts in the beam with no reduction in load, offering installation flexibility on the job site
• Domestic manufacturing - produced in the United States, supporting consistent quality standards and reliable availability for construction projects

Why This Product

• Purpose-built for structural right-angle connections - the heavy L-shaped angle design addresses one of the most common framing challenges directly, reinforcing corners and 90 deg. joints in wood assemblies where connection integrity is critical
• Hot-dip galvanized protection for long-term durability - the coating goes beyond standard galvanized finishes, making this connector a practical choice for framing applications where moisture exposure could compromise lesser hardware over time
• Installation flexibility with no load penalty - the ability to substitute lag screws for bolts in the beam without any reduction in load means crews can adapt to job site conditions without sacrificing performance
• Scalable to multi-directional load demands - when used in pairs, the connector achieves lateral loads in both directions, allowing it to serve a wider range of structural requirements within a single, consistent hardware solution

Specifications

• Model Number: HL43HDG
• Description: Angle
• Gauge: 3
• Width-1: 4-1/4 in.
• Width-2: 4-1/4 in.
• Length: 3 in.
• Coating / Material: Hot-Dip Galvanized
• Width 2: 4-1/4 in.
• Width 1: 4-1/4 in.
• Country of Origin: United States

Installation

• Install with (2) 3/4 in. diameter bolts.
• Lag screws of equal diameter (minimum 5 in. long) may be substituted for bolts in the beam with no reduction in load.

Approved Applications

• Right-angle connections where two structural members meet at 90 deg.
• Corner reinforcement in wood framing assemblies
• Applications requiring resistance to uplift and lateral forces
• Installations where lateral loads in both directions must be achieved (when installed in pairs)
• General heavy-duty utility strap connections in construction framing

Disclaimer: Product dimensions and/or screw or bolt holes may differ from picture. Please see item description for specifications.