Simpson Strong-Tie VTCR Single-Sided Valley Truss Clip is engineered by Simpson Strong-Tie to provide a positive connection between the valley truss and the supporting framing below. Installed on top of the roof sheathing, the VTCR eliminates the need to add a support wedge under the valley truss or to bevel the bottom chord to match the roof pitch - simplifying installation while delivering a reliable structural connection.

Key Features

• Single-sided for new construction or retrofit applications - can be installed after the valley truss is set in place
• Accommodates pitches from 0/12 to 12/12
• Can be installed on either beveled or non-beveled bottom chords
• Dome holes assist in installing the fasteners into the supporting framing at approximately 45 deg.
• Made from 18-gauge steel
• Galvanized (G90) for extra corrosion resistance
• Installs with nails or Simpson Strong-Tie Strong-Drive SD Connector screws

Specifications

• Model Number: VTCR
• Gauge: 18
• Coating: Zinc Galvanized, G90
• Finish: Zinc Galvanized, G90
• Fastener Requirements: Install with 10d common nails in the framing and 10d x 1-1/2 in. nails in the valley truss, or #9 x 2-1/2 in. Strong-Drive SD Connector screws in the framing and #9 x 1-1/2 in. SD screws in the valley truss
• Country of Origin: United States

Frequently Asked Questions

Can the VTCR be used on an existing roof without removing the valley truss?

Yes. Because the VTCR is single-sided, it can be installed after the valley truss is already set in place, making it suitable for both new construction and retrofit applications.

Does the VTCR require the valley truss bottom chord to be beveled?

No. The VTCR can be installed on either beveled or non-beveled bottom chords, and it eliminates the need to bevel the bottom chord to match the roof pitch.

What roof pitches does the VTCR accommodate?

The VTCR accommodates pitches from 0/12 to 12/12, providing flexibility across a wide range of roof slope configurations.

What fasteners are recommended for installing the VTCR?

The VTCR installs with 10d common nails in the framing and 10d x 1-1/2 in. nails in the valley truss, or alternatively with #9 x 2-1/2 in. Strong-Drive SD Connector screws in the framing and #9 x 1-1/2 in. SD screws in the valley truss. The dome holes assist in driving fasteners into the supporting framing at approximately 45 deg..